Previous
Contents
Next
5. Control Loader Software Data Output Format
For use with BLDRV-12/24 driver
cards the data output mode must be set to “10b” in the Pry_S.cfg
file.
The force loop rate should be in
the region of 50Hz for the brushless drives.
The serial comms runs at 519126
baud – this is set in the FFB settings .cfg file.
Additional simple 8 and 16bit data
output modes are available from the CL software – contact me for
more details. Note these additional output formats are present but
are no longer actively supported.
Previous
Contents
Next
|