BFF Shaker Software - Short User Guide


Previous    Contents     Next

4. Settings for X-Plane Use

The Shaker software runs with X-Plane v9.6+.

The software uses XPUIPC v1.9.0+ to communicate with X-Plane 9.6+.

Install XPUIPC according to the XPUIPC user documentation. Note that the simulation data CPS of the CL software is shown on its GUI window when running you may need this value to check speed matching between the XPUIPC data output and the CL software.

IN ADDITION the XPUIPCOffsets.cfg file supplied in the BFF Shaker Software folder must be copied to the X-Plane/Resources/plugins folder. This allows XPUIPC to set up the required custom data offsets not currently hard-coded into XPUIPC v1.9.0. If there is already a copy of XPUIPCOffsets.cfg in the plugins folder then the contents of the Shaker software version should be added to the end of the existing .cfg file. You can use a simple text editor to do this (eg NotePad).

Note the location of the .cfg in v2 is slightly different - read the XPUIPC documentation.

See for XPUIPC.


Previous    Contents     Next

Copyright © 2013 BFF Design Ltd All Rights Reserved.